Boiler controller MOG-1000-O2K
Boiler computer system with O2-Controller
Description
The MOG-1000-O2K boiler computer is developed to optimize heat production for the best economy at your plant, and to supply maintenance personnel with information that will simplify their work.
The MOG-1000-O2K boiler computer is based on a microcontroller and electronic process memories, which makes the MOG-1000-O2K very flexible. The MOG-1000-O2K can be programmed for use with practically any type of boiler, Owen, burner or fuel.
The individual functions and operating parameters are programmed into the computers memory for each boiler using the built-in keypad. Programming can also be done remotely using the MDS-10 or MOS-1000 Operator System HMI interface.
MOG-1000-O2K for biofuel firing:
prepared for use with all types of boilers;
Hot water boilers Steam boilers Hot oil-fired boilers Biomass boilers MOG-1000-O2K for non-biofuel firing:
prepared for use on all types of boilers;
Hot water boilers Steam boilers Oil-fired boilers Gas-fired boilers Coal-fired boilers Natural draught boilers Induced draught boilers Forced draught boilers Positive/Negative pressure furnace Functions
Temperature or steam pressure control:
Control functions for start and stop of burners On/Off controller for speed flue gas fan On/Off controller for combustion air fans and fuel supply Power controller (3-point PI controller) for modulating burners Sequel control of set points for On/Off controller and Power controller Control of negative pressure in the furnace or control of combusted air:
Evacuation of gases at burner stop Manual/Auto switch Downtime pressure for biomass fired boilers Sweeping position O2-Control:
O2-controller with a programmable set point curve Alarms:
Alarm functions for sequential control of boilers and remote indication Communication:
Data communication with computer Monitoring with limits for warning and stop:
Monitoring of the pressure in the furnace or the differential pressure Monitoring of the flue gas temperature Monitoring of the O2-content in the flue gases Monitoring of combustion efficiency Monitoring of oil and gas consumption Monitoring of optional temperature (for example combusted air or oil). This temperature may also be controlled if the power control is not used Monitoring of mA signals Switches:
Fan guard (for induced draught boilers)
Pressure switch, positive or differential, separate from the MOG-1000-O2K
Contact form
